From mboxrd@z Thu Jan 1 00:00:00 1970 From: Albert ARIBAUD Date: Sun, 31 Oct 2010 22:55:58 +0100 Subject: [U-Boot] [RFC] arm926ejs: fix jump to RAM nand_boot In-Reply-To: <20101031215118.95D6EEA47F@gemini.denx.de> References: <20101031203243.478E9EA47F@gemini.denx.de> <1288547025-16877-1-git-send-email-albert.aribaud@free.fr> <20101031181244.419EDEA47F@gemini.denx.de> <4CCDB78D.506@ahsoftware.de> <20101031190136.64829EA47F@gemini.denx.de> <4CCDBE71.1010805@free.fr> <20101031192243.7AF531522C0@gemini.denx.de> <4CCDC625.3010209@free.fr> <20101031195941.5AB961522C0@gemini.denx.de> <4CCDD02D.2050304@free.fr> <1288560046-6458-1-git-send-email-albert.aribaud@free.fr> <20101031215118.95D6EEA47F@gemini.denx.de> Message-ID: <4CCDE5EE.5090203@free.fr> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Le 31/10/2010 22:51, Wolfgang Denk a ?crit : > Dear Albert Aribaud, > > In message<1288560046-6458-1-git-send-email-albert.aribaud@free.fr> you wrote: >> RFC again. WARNING -- apply *above* the previous one, not instead! >> >> I *think* the current jump to nand_boot was wrong, because it >> loads an offset but does not add it to the relocated base before >> jumping to it. I thus applied the same sequence as board_init_r. >> >> Wolfgang, please test to see if tx25 works with this. > > Doesn't work at all for me - zero cosole output; neither with ELDK nor > with CS toolchains. That's when I wish I had a tx25 board here. :( Back to staring at the source code... > Best regards, > > Wolfgang Denk Amicalement, -- Albert.