[U-Boot] [PATCH] FSL_ESDHC: Make the base address configurable at runtime

[Stefano Babic <sbabic@denx.de>]

On 11/14/2010 06:01 PM, Marek Vasut wrote:

> Hi Wolfgang,
> 
> it means Stefano explained to me he already tried pushing in such a patch and 
> the patch was rejected. Therefore, I assume you should ignore this patch.

To complete the explanation: there is already a way to make address
configurable and we do not need to change fsl_esdhc_mmc_init.

The fsl_esdhc_initialize(bd_t *bis, struct fsl_esdhc_cfg *cfg) was added
to the driver when I pushed the MX51 stuff, allowing us to set up the
base address, Not only, the struct fsl_esdhc_cfg could be extended in
the future, if we will need it (but not at the moment, as I know).

This way is already used by the mx51evk (both SDHC controller are
supported) and by the vision2 (only one SDHC controller is supported).

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================