From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefano Babic Date: Fri, 19 Nov 2010 08:28:28 +0100 Subject: [U-Boot] [PATCH v6 1/1] imx: Get fec mac address from fuse In-Reply-To: References: <1290080989-9101-1-git-send-email-r64343@freescale.com> <4CE52C39.3050406@denx.de> Message-ID: <4CE6271C.9090608@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 11/19/2010 07:44 AM, Jason Liu wrote: >> I think you are right. I did not have the mx27 board to do test. >> Thanks for test. >> >> I only test it on mx51babbage board, the following is the output: >> >> Net: got MAC address from fuse: 00:04:9f:00:f7:78 >> which is the same as the MAC address programmed on the board. > > > Do you have any other comments about this patch? As I have not seen any other comments in the ML, I have tried to apply the patch and to test myself. From my point of view we have to be sure that the patch is working for all supported processors, and I can test it for i.MX27. As you already test it on i.MX51, can you test it on i.MX25 ? Or at least check with tracing if the address is correct for this processor, too ? Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office at denx.de =====================================================================