[U-Boot] Build failures with older toolchain

[Albert ARIBAUD <albert.aribaud@free.fr>]

Le 01/12/2010 15:56, Premi, Sanjeev a ?crit :

> When everything failed, I went back to the u-boot.lds and
> changed the way overlay is defined.
>
> ...AND PROBLEM SEEMS TO BE SOLVED!

This most probably means some of the code running before relocation uses 
BSS; see below.

> I can now compile u-boot with both 2009q1 and 2010q1 without
> any error. (yet to try with 2010.09)
>
> To verify, I wanted to do a before-and-after comparison but
> couldn't have done for the omap3_evm - used omap3_beagle instead.
>
> I haven't yet tried running the binary on the board; but here
> are top level observations:
>
> 1) .bss and .rel.dyn are starting at same address.

This is normal and should not have any negative impact as long as code 
that runs before relocation does not access BSS -- and it should not, 
since BSS only exists after relocation.

> 2) The size of .rodata has increased. (Why? not yet spent time on?)

Weird. Can you provide all necessary info for duplicating these two builds?

> Sending the patch in next few mins:

If that's a patch to remove the overlay in the .lds, it's a Nak from me 
already.

> ~sanjeev

Amicalement,
-- 
Albert.