From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefano Babic Date: Thu, 16 Dec 2010 18:41:08 +0100 Subject: [U-Boot] [PATCH 3/3] fsl_esdhc: Fix the voltage validation process In-Reply-To: <1292401217-21154-4-git-send-email-galak@kernel.crashing.org> References: <1292401217-21154-1-git-send-email-galak@kernel.crashing.org> <1292401217-21154-2-git-send-email-galak@kernel.crashing.org> <1292401217-21154-3-git-send-email-galak@kernel.crashing.org> <1292401217-21154-4-git-send-email-galak@kernel.crashing.org> Message-ID: <4D0A4F34.2050702@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 12/15/2010 09:20 AM, Kumar Gala wrote: > From: Li Yang > > The current code use all the voltage range support by the host > controller to do the validation. This will cause problem when > the host supports Low Voltage Range. Change the validation > voltage to be based on board setup. > > Signed-off-by: Li Yang > --- Tested-by: Stefano Babic Regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office at denx.de =====================================================================