[U-Boot] [PATCH v2 1/3] MX5: Add initial support for MX53 processor

[Stefano Babic <sbabic@denx.de>]

On 12/22/2010 02:23 PM, Jason Liu wrote:
> Add initial support for Freescale MX53 processor,
> 
> - Add the iomux support and the pin definition,
> - Add the regs definition, clean up some unused def from mx51,
> - Add the low level init support, make use the freq input of setup_pll macro
> 
> ---
> Changes for v2:
> -address some comments of Stefano Babic, remove the is_soc_type
>  and use #ifdef,
> -address the comments of stefano, remove CPU_TYPE def, remove something
>  like /*0x760*/ comments in mx5x_pins.h.
> -fix the build break for vision2 board

A general remark. You posted two different patchset now to support the
MX53 processor. As the patches are related, please combine all patches
in a single patchset to avoid that only a few of them go to be applied
and to simplify review.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================