[U-Boot] [PATCH V5 2/4] serial: Add Tegra2 serial port support

[Mike Rapoport <mike@compulab.co.il>]

Tom,

On 01/26/11 19:05, Tom Warren wrote:
> Mike,
> 
> On Wed, Jan 26, 2011 at 1:13 AM, Mike Rapoport <mike@compulab.co.il> wrote:
>> My point was that pin muxing belongs to the board code rather than to the
>> driver. Driver should just assume that pins are configured elsewhere and it does
>> not need to deal with pin muxing at all.
> I understand that point - sorry if I wasn't clear. No objection to
> having pinmux code in board files.
> 
>> Moreover, I'd prefer to see pinmux_board_init or something similar that
>> configures all the pins at once rather than collection of pinmux_init_uart,
>> pinmux_init_sdmmc, pinmux_init_gmi etc that will grow as more drivers are added.
>>
> I see a couple of reasons not to do it that way. First, I don't know
> at this time what all the pinmux settings will be, since I haven't
> ported all the periph driver code yet. It's vastly different from
> what's acceptable in U-Boot, and will all need significant rewrite.
> It'd take me a week to gather all that info, and I'm not at full BW on
> this project (one of 4 on my plate right now).
> Second, I've been chastised before for including code/features in this
> initial patchset that aren't needed or used.  I'm trying to keep the
> code as simple as possible to make it easier on reviewers and get
> through the review in as short a time as possible. This has already
> dragged on far longer than I thought it would.
> I'm willing to change the pinmux code to make it as generic as
> possible, but only if there's a consensus on the list that it has to
> be that way to get accepted & pushed.

I'm Ok with pinmux_init_uart in the board code for now. I think that the generic
pinmux functionality can be added afterwards.

>>
> Thanks,
> Tom


-- 
Sincerely yours,
Mike.