[U-Boot] Q: MII read

[Stefano Babic <sbabic@denx.de>]

On 03/13/2011 09:24 AM, Ran Shalit wrote:
> Hello,
> 
Hi Ran,

> I would like to ask a question regarding the MII functionality :
> When using mii commands (cmd_mii.c) everything works well, until trying to
> do a ping (using net command).
> After any ping try(with success or not), the mii read function is
> stuck.  Maybe it has to do with davinci mii implementation, but I am not
> sure if this is the problem or not.
> Any advice is welcomed.

I think this is not a general issue, as with other processors/boards
everything works fine. However, after using a net command, the dev->halt
callback is called, and this could disable the phy.

If you are using the davinci_emac driver, take a look at the
davinci_eth_close() function. It can be that when the controller is
turned off, you cannot access to the phy anymore.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================