[U-Boot] Non-working Relocated DNS323 config

[Rogan Dawes <rogan@dawes.za.net>]

On 2011/03/18 12:53 PM, Prafulla Wadaskar wrote:
>> -----Original Message-----
>> From: u-boot-bounces at lists.denx.de [mailto:u-boot-bounces at lists.denx.de]
>> On Behalf Of rogan at dawes.za.net
>> Sent: Friday, March 18, 2011 1:40 PM
>> To: u-boot at lists.denx.de
>> Subject: [U-Boot] Non-working Relocated DNS323 config
>>
>> This patch series contains the previous working configuration for
>> the DNS323, forward-ported to mainline, taking into account changes
>> made to the EDMiniV2 configuration on which this is based.
>>
>> Unfortunately, this does not boot at all. I get:
>>
>> Marvell>> bootm
>> ## Booting image at 00100000 ...
>>    Image Name:   UBoot dns323
>>    Image Type:   ARM U-Boot Kernel Image (uncompressed)
>>    Data Size:    170100 Bytes = 166.1 kB
>>    Load Address: 03000000
>>    Entry Point:  03000000
>>    Verifying Checksum ... OK
>> OK
>>
>> Starting kernel ...
> 
> There might be machine id mismatch in the kernel and programmed in u-boot for this board.
> 
> Regards..
> Prafulla . .

Hi Prafulla,

That log is of me trying to chain load the new U-Boot from the vendor
U-Boot. I am not yet ready to try flashing images, because my JTAG
adapter has not yet arrived and been proved working :-)

What I was expecting to see after the "Starting kernel ..." was the new
U-Boot starting up. Instead, it simply hung.

The "working config" gives me:

Starting kernel ...



U-Boot 2010.06 (Mar 18 2011 - 13:24:33) DNS323B1

SoC:   Orion5x MV88F5182-A2
DRAM:  64 MiB
Flash: 8 MiB
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
Net:   egiga0
88E1116 Initialized on egiga0
DNS323B1>

The non-working one just hangs.

Regards,

Rogan