[U-Boot] [PATCH] mpc83xx: restrict UTMI PHY configuration to 831x parts

[Andre Schwarz <andre.schwarz@matrix-vision.de>]

Kim,

excellent - thanks.

> i.e, to those parts that have PHY_CLK_VALID bits in their USB
> CONTROL registers:
>
> mpc8308	 WU_INT, PHY_CLK_SEL, USB_EN, WU_INT_EN, ULPI_INT_EN
> mpc831x	 PHY_CLK_VALID, WU_INT, CLKIN_SEL, PHY_CLK_SEL, UTMI_PHY_EN,
> 	 PLL_RESET, REFSEL, OTG_PORT, KEEP_OTG_ON, LSF_EN, USB_EN,
> 	 ULPI_INT_EN
> mpc834x	 USB_EN, ULPI_INT1_EN (MPH only), ULPI_INT0_EN
> mpc837x	 USB_EN, ULPI_INT_EN
>
> (mpc832x, mpc8360 don't have a USB_EHCI_FSL compatible controller)
>
> this prevents non-831x parts from never completing cpu_init_f(),
> because the (non-existent) PHY_CLK_VALID bit never gets set.
>
> Reported-by: Andre Schwarz<andre.schwarz@matrix-vision.de>
> Signed-off-by: Kim Phillips<kim.phillips@freescale.com>
Tested-by: Andre Schwarz <andre.schwarz@matrix-vision.de>

Works on MPC8343 and MPC8377.

> ---
>   arch/powerpc/cpu/mpc83xx/cpu_init.c |    4 +---
>   1 files changed, 1 insertions(+), 3 deletions(-)
>
> diff --git a/arch/powerpc/cpu/mpc83xx/cpu_init.c b/arch/powerpc/cpu/mpc83xx/cpu_init.c
> index 7a1cae7..76afba5 100644
> --- a/arch/powerpc/cpu/mpc83xx/cpu_init.c
> +++ b/arch/powerpc/cpu/mpc83xx/cpu_init.c
> @@ -326,8 +326,7 @@ void cpu_init_f (volatile immap_t * im)
>   	im->gpio[1].dat = CONFIG_SYS_GPIO2_DAT;
>   	im->gpio[1].dir = CONFIG_SYS_GPIO2_DIR;
>   #endif
> -#ifdef CONFIG_USB_EHCI_FSL
> -#ifndef CONFIG_MPC834x
> +#if defined(CONFIG_USB_EHCI_FSL)&&  defined(CONFIG_MPC831x)
>   	uint32_t temp;
>   	struct usb_ehci *ehci = (struct usb_ehci *)CONFIG_SYS_FSL_USB_ADDR;
>
> @@ -340,7 +339,6 @@ void cpu_init_f (volatile immap_t * im)
>   		udelay(1000);
>   	} while (!(temp&  PHY_CLK_VALID));
>   #endif
> -#endif
>   }
>
>   int cpu_init_r (void)

Cheers,
Andr?



MATRIX VISION GmbH, Talstrasse 16, DE-71570 Oppenweiler
Registergericht: Amtsgericht Stuttgart, HRB 271090
Geschaeftsfuehrer: Gerhard Thullner, Werner Armingeon, Uwe Furtner