From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefano Babic Date: Fri, 22 Apr 2011 11:11:54 +0200 Subject: [U-Boot] [PATCH V5 2/2] MX53: support for freescale MX53LOCO board In-Reply-To: References: <1303296425-14806-1-git-send-email-jason.hui@linaro.org> <1303296425-14806-3-git-send-email-jason.hui@linaro.org> <4DB06CBE.8050803@denx.de> <4DB126CE.30901@denx.de> Message-ID: <4DB1465A.4050302@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 04/22/2011 10:33 AM, Jason Liu wrote: > > Is there any rule that we need must follow to set the > CONFIG_SYS_MEMTEST_START > CONFIG_SYS_MEMTEST_END ?? There is no rule, it was only a question if there are some specific reasons. > > If no, I think the value we set is free. Here I set for 64KB is just > for simple and quick > test, there is no other reasons. > > In fact, mtest command line can override the value. That is correct. > > What the value you think I need set? As I said, there is no rule. You choose the value you think it is better for your board as default values for mtest. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office at denx.de =====================================================================