From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefano Babic Date: Tue, 17 May 2011 14:44:58 +0200 Subject: [U-Boot] [PATCH v2 1/3] MX5: Make the weim structure complete In-Reply-To: References: <1305584991-13040-1-git-send-email-fabio.estevam@freescale.com> Message-ID: <4DD26DCA.606@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 05/17/2011 07:06 AM, Jason Liu wrote: > Hi, Fabio, > > 2011/5/17 Fabio Estevam : >> Make the weim register set complete for MX51/MX53. >> >> While at it also add the weim chip select 1 address definition. >> > > From the code, you just add the cs for mx53 not for mx51, so, > Had better specify you add the cs1 address definition for mx53, > otherwise, it will make confusion. Sure ? The structure is not protected by any CONFIG_MX5x switch, and at least one mx51 board uses it. The registers have the same layout for both processor. Why do you think is only for MX53 ? Regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office at denx.de =====================================================================