From mboxrd@z Thu Jan 1 00:00:00 1970 From: Simon Schwarz Date: Thu, 11 Aug 2011 09:26:57 +0200 Subject: [U-Boot] [PATCH 8/9] DM9000: change some printf to use debug instead In-Reply-To: <20110810203340.21204.45508.stgit@shuttle2.etheralp.ch> References: <20110810200828.21204.60050.stgit@shuttle2.etheralp.ch> <20110810203340.21204.45508.stgit@shuttle2.etheralp.ch> Message-ID: <4E438441.6040409@gmail.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Eric Jarrige, On 08/10/2011 10:33 PM, Eric Jarrige wrote: > Signed-off-by: Eric Jarrige > Cc: Ben Warren > --- > drivers/net/dm9000x.c | 8 ++++---- > 1 files changed, 4 insertions(+), 4 deletions(-) > > diff --git a/drivers/net/dm9000x.c b/drivers/net/dm9000x.c > index b5c5573..9cd0195 100644 > --- a/drivers/net/dm9000x.c > +++ b/drivers/net/dm9000x.c > @@ -232,7 +232,7 @@ dm9000_probe(void) > id_val |= DM9000_ior(DM9000_PIDL)<< 16; > id_val |= DM9000_ior(DM9000_PIDH)<< 24; > if (id_val == DM9000_ID) { > - printf("dm9000 i/o: 0x%x, id: 0x%x \n", CONFIG_DM9000_BASE, > + DM9000_DBG("dm9000 i/o: 0x%x, id: 0x%x \n", CONFIG_DM9000_BASE, > id_val); > return 0; > } else { > @@ -298,19 +298,19 @@ static int dm9000_init(struct eth_device *dev, bd_t *bd) > > switch (io_mode) { > case 0x0: /* 16-bit mode */ > - printf("DM9000: running in 16 bit mode\n"); > + DM9000_DBG("DM9000: running in 16 bit mode\n"); I'am just wondering: I see that DM9000_DBG is used all over dm9000 code - do you know the reason why not just use debug()? Regards Simon