[U-Boot] [PATCH 1/9] OMAP3: CM-T35: Use generic MMC driver

[Igor Grinberg <grinberg@compulab.co.il>]

On 08/23/11 01:13, Tom Rini wrote:

> Switch from the legacy omap3 mmc driver to the new generic omap hsmmc
> driver.  This patch is based on the work done for Beagle, etc.
>
> Signed-off-by: Tom Rini <trini@ti.com>

It is a good practice to CC the board maintainer. Thanks.

Tested-by: Igor Grinberg <grinberg@compulab.co.il>

> ---
>  board/cm_t35/cm_t35.c    |    8 ++++++++
>  include/configs/cm_t35.h |    3 ++-
>  2 files changed, 10 insertions(+), 1 deletions(-)
>
> diff --git a/board/cm_t35/cm_t35.c b/board/cm_t35/cm_t35.c
> index f82111b..420cd70 100644
> --- a/board/cm_t35/cm_t35.c
> +++ b/board/cm_t35/cm_t35.c
> @@ -313,6 +313,14 @@ void set_muxconf_regs(void)
>  		cm_t3730_set_muxconf();
>  }
>  
> +#ifdef CONFIG_GENERIC_MMC
> +int board_mmc_init(bd_t *bis)
> +{
> +	omap_mmc_init(0);
> +	return 0;
> +}
> +#endif
> +
>  /*
>   * Routine: setup_net_chip_gmpc
>   * Description: Setting up the configuration GPMC registers specific to the
> diff --git a/include/configs/cm_t35.h b/include/configs/cm_t35.h
> index 16a5f5b..496a904 100644
> --- a/include/configs/cm_t35.h
> +++ b/include/configs/cm_t35.h
> @@ -108,8 +108,9 @@
>  #define CONFIG_BAUDRATE			115200
>  #define CONFIG_SYS_BAUDRATE_TABLE	{4800, 9600, 19200, 38400, 57600,\
>  					115200}
> +#define CONFIG_GENERIC_MMC		1
>  #define CONFIG_MMC			1
> -#define CONFIG_OMAP3_MMC		1
> +#define CONFIG_OMAP_HSMMC		1
>  #define CONFIG_DOS_PARTITION		1
>  
>  /* DDR - I use Micron DDR */

-- 
Regards,
Igor.