From mboxrd@z Thu Jan  1 00:00:00 1970
From: Stefano Babic <sbabic@denx.de>
Date: Thu, 01 Sep 2011 11:02:25 +0200
Subject: [U-Boot] Help: U-Boot on Nokia RX-51 (aka N900)
In-Reply-To: <2265056.NfLL5Fdny9@pali-elitebook>
References: <2265056.NfLL5Fdny9@pali-elitebook>
Message-ID: <4E5F4A21.5010502@denx.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

On 09/01/2011 10:42 AM, Pali Roh?r wrote:
> Hello,
> 

Hi Pali,

> U-Boot patches which add support for Nokia RX-51 (aka N900) is here:
> http://al.robotfuzz.com/~al/maemo/u-boot/

It is quite difficult to review patches in this way, considering you
have already changed something to adapt to the currect release. I
suggest you post your modified patches to ML.

> 
> RX-51 has closed 2nd stage bootloader NOLO which can load kernel image from 
> nand (or usb) to ram and boot it. NOLO also done all HW initializations. These 
> U-Boot patches for RX-51 add support that builded U-Boot binary can be loaded 
> and booted by NOLO. So U-Boot will be 3rd bootloader.
> 
> Patches are on top of revision bd2313078114c4b44c4a5ce149af43bcb7fc8854 and 
> working fine. I rebased these patches on top of u-boot git master repository, 
> but booting failed. No output on device. Using git bisect I found that problem 
> appeared at revision
> 
> 561142af20f1fd7b425d9425730014e656defb91
> ARM: implement relocation for ARM V7 (OMAP)
> 
> If I defined CONFIG_SYS_ARM_WITHOUT_RELOC U-Boot working and booting fine up to 
> revision a9aa3926295df759306258e5e24cace414f53b67
> 
> So problem is that relocation patches broke RX-51 support.

Well, it does mean that the RX51 was not adapted for the relocation...

You should take care that the initial stackpointer (check for
CONFIG_SYS_INIT_SP_ADDR) is set to a a range into RAM (or internal RAM,
if any) and it is not overwritten by other parts (where is your TEXT
code ?).

Move all first initialization into board_early_init_f, if any.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================