[U-Boot] [PATCH v3] arm926ejs: add NXP LPC32x0 cpu series support

[Vladimir Zapolskiy <vz@mleia.com>]

Hi Albert,

On 22.10.2011 02:31, Albert ARIBAUD wrote:
> Hi Vladimir,
>
> Le 18/10/2011 17:55, Vladimir Zapolskiy a ?crit :
>> This change adds initial support for NXP LPC32x0 SoC series.
>>
>> Signed-off-by: Vladimir Zapolskiy<vz@mleia.com>
>> ---
>> Changes from v2 to v3:
>> * checkpatch.pl reports zero errors and warnings
>>
>> Changes from v1 to v2:
>> * BIT(n) and SBF(s, v) macro are not used anymore
>> * removed NS16550 and 14-clock UART definitions from uart.h
>> * added devices.c file, which contains standard UART preinitialization
>> routine
>> * added get_serial_clock() function, it returns actual frequency of
>> UART clock
>> * __udelay() realization is simplified, no need of interrupt handling
>
> As it stands, this is dead code until some board uses it; I imagine you
> have board waiting for this support. Can you submit the SoC and board
> code as a patch set? This way, it will be obvious for all that the SoC
> code in this patch has actual use.

you're right, I have a board to make support for. However I presume that 
U-boot maintainers won't be happy to include a board with 
CONFIG_ENV_IS_NOWHERE, and unfortunately flash driver isn't yet ready 
for publishing.

I'd like to get an advice, if you think that weakly supported but 
working U-boot on the board has chances to be included to arm-next I can 
send the patchset right now for review, otherwise I'll spend some time 
(one week approximately) to finish NAND driver.

-- 
With best wishes,
Vladimir