[U-Boot] [PATCH 1/2] OMAP3 SPL: Rework memory initalization and devkit 8000 support

[Tom Rini <trini@ti.com>]

On 10/27/2011 01:46 PM, Igor Grinberg wrote:
> Hi Tom,
> 
> That seems like a good change, though I would recommend to split it into
> smaller
> patches, please, see below:
> 
> On 10/26/2011 11:13 PM, Tom Rini wrote:
>> This changes to making the board be responsible for providing the
>> memory initialization timings in SPL
> 
> That probably would be one patch.
> 
>>  and converts the devkit 8000
>> to this framework.
> 
> That, would be another one.

But breaking it up like this breaks bisect'ability as devkit8000 builds
today (well, outside of the scope of this series).

>>   As part of this suffix the Micron DDR settings
>> with their speed
> 
> Next patch.

OK.

> 
>>  and add a few more timing values that will be needed.
> 
> This can go along with the patch that uses those settings.

I'll double check where they're really neded.

>> We also make sure that in mem_ok() we clear the values off as we may be
>> testing the same banks multiple times.
> 
> That's should be another patch (although it has only one line).

Sure.  Again, the bigger picture right now I'm hoping for is:
(a) does it work on all of the other beagleboard revs?  The logic is a
little twisty but it's what x-loader does today and (b) does the overall
approach look sane to everyone?

Thanks!

-- 
Tom