[U-Boot] [GIT PULL] Pull request: u-boot-imx

Stefano Babic
2010-04-19T13:52:46Z

Hi Tom,

The following changes since commit 7c33c16f3bf53e563aa57e25e2399d0069a08749:
Stefano Babic (1):
Moved board specific values in config file

are available in the git repository at:

git://www.denx.de/git/u-boot-imx.git master

John Rigby (1):
MX25 print arm clock instead of mpllclk on boot

Stefano Babic (8):
mkimage: correct spelling error in imximage
mx51evk: correct list of possible BOOT_FROM values
MX31: add accessor function to get a gpio
MX31: add pin definitions for NAND controller
MX31: Add support for NAND to QONG board
MX31: Support 128MB RAM on QONG module
MX31: Add UBI support to QONG module
MX31: Removed erroneous board name from QONG

arch/arm/cpu/arm926ejs/mx25/generic.c | 2 +-
arch/arm/include/asm/arch-mx31/mx31-regs.h | 15 +++
arch/arm/include/asm/arch-mx31/mx31.h | 5 +
board/davedenx/qong/lowlevel_init.S | 130
+++++++++++++++++++++-------
board/davedenx/qong/qong.c | 95 ++++++++++++++++-----
board/davedenx/qong/qong_fpga.h | 4 +-
board/freescale/mx51evk/imximage.cfg | 2 +-
drivers/gpio/mx31_gpio.c | 15 +++
include/configs/qong.h | 40 ++++++++-
tools/imximage.c | 2 +-
10 files changed, 246 insertions(+), 64 deletions(-)

Thanks,
Stefano

--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office at denx.de
=====================================================================