From mboxrd@z Thu Jan 1 00:00:00 1970 From: Heiko Schocher Date: Wed, 09 Nov 2011 13:26:20 +0100 Subject: [U-Boot] [PATCH] arm, davinci_emac: fixup In-Reply-To: References: <1320819979-3861-1-git-send-email-hs@denx.de> Message-ID: <4EBA716C.5000105@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hello Prabhakar Lad, Prabhakar Lad wrote: > Hi Heiko, > > On Wed, Nov 9, 2011 at 11:56 AM, Heiko Schocher wrote: [...] >> Signed-off-by: Heiko Schocher >> Cc: Sandeep Paulraj >> Cc: Albert ARIBAUD >> Cc: Wolfgang Denk >> Cc: Manjunath Hadli >> --- >> drivers/net/davinci_emac.c | 17 +++++++++++------ >> 1 files changed, 11 insertions(+), 6 deletions(-) >> >> diff --git a/drivers/net/davinci_emac.c b/drivers/net/davinci_emac.c >> index fa31159..a31e9f1 100644 >> --- a/drivers/net/davinci_emac.c >> +++ b/drivers/net/davinci_emac.c [...] >> @@ -175,7 +174,13 @@ static int davinci_eth_phy_detect(void) >> for (i = 0, j = 0; i < 32; i++) >> if (phy_act_state & (1 << i)) { >> count++; >> - active_phy_addr[j++] = i; >> + if (count < MAX_PHY) >> + active_phy_addr[j++] = i; >> + else { >> + printf("%s: to much PHYs detected.\n", >> + __func__); >> > why not make here count = 0 and then break, so that later > in davinci_emac_initialize() it wont initializes the phy's I prefer here the error printf, because you see immediately what is wrong... bye, Heiko -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany