[U-Boot] [PATCH 4/5] mx53smd: Configure the pins as GPIOs prior to using gpio_get_value

[Stefano Babic <sbabic@denx.de>]

On 11/15/2011 04:51 PM, Fabio Estevam wrote:
> Configure the pins as GPIO prior to using gpio_get_value.
>
> Signed-off-by: Fabio Estevam<fabio.estevam@freescale.com>
> ---
>   board/freescale/mx53smd/mx53smd.c |    1 +
>   1 files changed, 1 insertions(+), 0 deletions(-)
>
> diff --git a/board/freescale/mx53smd/mx53smd.c b/board/freescale/mx53smd/mx53smd.c
> index 87fa7fa..55af4e4 100644
> --- a/board/freescale/mx53smd/mx53smd.c
> +++ b/board/freescale/mx53smd/mx53smd.c
> @@ -134,6 +134,7 @@ struct fsl_esdhc_cfg esdhc_cfg[1] = {
>
>   int board_mmc_getcd(u8 *cd, struct mmc *mmc)
>   {
> +	mxc_request_iomux(MX53_PIN_EIM_DA13, IOMUX_CONFIG_ALT1);
>   	*cd = gpio_get_value(77); /*GPIO3_13*/
>
>   	return 0;

Applied to u-boot-imx, thanks

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================