[U-Boot] [PATCH V3] nand_spl_simple: store ecc data on the stack

[Stefano Babic <sbabic@denx.de>]

On 13/12/2011 19:45, Scott Wood wrote:
> On 12/13/2011 12:33 PM, Tom Rini wrote:
>> So, we have various characteristics of the NAND chip that need to be
>> described for SPL.  Today we do CONFIG_SYS_NAND... but they're
>> unchanged in every implementation and are calculated from other
>> per-board values.  So to avoid duplication in each config file, we
>> drop them from there and use them only locally #define calculate them
>> in the file that needs them.  Since they're still system specific
>> values, I had suggested calling them SYS_... but I wasn't sure what
>> the right namespace is.  I had a recollection that using CONFIG_
>> outside of config files was a bad idea.
> 
> These symbols are not in a header file -- how about just plain ECCSTEPS
> and ECCTOTAL?

Ok, agree - done in V4.

Regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================