[U-Boot] [PATCH v2 1/3] mx28: Let imx_get_mac_from_fuse be common for mx28

[Stefano Babic <sbabic@denx.de>]

On 16/12/2011 10:53, Marek Vasut wrote:
>> On 15/12/2011 18:22, Marek Vasut wrote:
>>>> Let imx_get_mac_from_fuse function be a common function, so that other
>>>> mx28 boards can reuse it.
>>>>
>>>> Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
>>

Hi Marek,


>>> Be careful here. 0x00 0x04 prefix might not be correct for all cases!
>>
>> But to be honest, it seems they are correct for the MX28EVK and not for
>> the M28EVK. The M28EVK and the M28 module are delivered with their own
>> MAC address that does not belong to the Freescale's range.
>>
>> As far as I can see, the M28EVK starts with a Freescale's MAC, and then
>> the DENX MAC address (Vendor ID C0:E5:4E) is set later to the correct
>> value when Linux boots.
> 
> It's actually set even in uboot by ethaddr and eth1addr. This is the default 
> behaviour.

This means ethaddr overwrites the values read from fuses - why do we
need the fuses ?

> 
>>
>> I can understand this feature in the SOC as a way to set the LSBs of the
>> MAC address, but leaving to the customer a way to set its own vendor id,
>> if he bought it.
>>
>> What about to add a weak function (board_set_mac_vendor, maybe ?) that
>> can be called at this point to set the vendor id ? The default behavior
>> should be to set the Freescale's vendor id.
> 
> ethaddr and eth1addr is insufficient?

In a standard way, the environment must be adapted for each board to
store the MAC address in the ethaddr variable. The reason to get the MAC
directly from the hardware is that it is not required a specific initial
setup for each board, and that simplifies the production and the
delivery of the boards.

If you rely on ethaddr, than we do not need imx_get_mac_from_fuse() at
all, and the MAC can be set to zero, because in this case the ethaddr
value is used - but we lose the feature.

The reason why imx_get_mac_from_fuse was introduce is to have an
automatic mechanism to set up the MAC without any customization.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================