From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefano Babic Date: Wed, 01 Feb 2012 12:30:04 +0100 Subject: [U-Boot] [PATCH V6 - Part 3 - 0/2] SPI flash enhancements: allow default bus and chip-selects In-Reply-To: <4F283D9F.2020506@boundarydevices.com> References: <1328032330-20883-1-git-send-email-eric.nelson@boundarydevices.com> <1328032330-20883-6-git-send-email-eric.nelson@boundarydevices.com> <201201311311.05336.vapier@gentoo.org> <4F283D9F.2020506@boundarydevices.com> Message-ID: <4F29223C.8080401@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 31/01/2012 20:14, Eric Nelson wrote: > On 01/31/2012 11:11 AM, Mike Frysinger wrote: >> On Tuesday 31 January 2012 12:52:06 Eric Nelson wrote: >>> Patch 1 modifies the 'sf' command to allow a default bus and chip-select >>> to be specified by board headers. This allows a bare 'sf' probe command: >>> U-Boot> sf probe >>> instead of the more cumbersome usage when a GPIO is tacked onto >>> the chip-select. Otherwise, this command-line would be needed >>> to specify GP3:19 on SabreLite: >>> U-Boot> sf probe 0x5300 >>> >>> Patch 2 provides a description of usage and configuration of >>> CONFIG_CMD_SF. >> >> you can drop these two SF patches from your mx6q series. i don't want >> to keep >> checking to see if you've updated them :p. >> -mike > > I figured as much, but I can't really test them without the rest of the > series... It does not matter - Mike, what do you think if I merge the whole patchset into u-boot-imx ? Else the mx6qsabrelite board cannot be built until all patches will be merged by Wolfgang. Stefano -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office at denx.de =====================================================================