[U-Boot] ARM: Update mach-types

[stefano babic <sbabic@denx.de>]

Am 28/02/2012 04:51, schrieb Marek Vasut:
>> On 2/27/2012 3:56 PM, Marek Vasut wrote:
>>>> |ARM: Update mach-types
>>>> |
>>>> |This commit updates the mach-types based on the latest in Linus's
>>>> head |
>>>> |Signed-off-by: Marek Vasut<marek.vasut@gmail.com>
>>>>
>>>> Hi Marek,
>>>>
>>>>
>>>> Can I get you to do this again? I'd the symbol for
>>>> MACH_MX6Q_SABRELITE.
>>>
>>> No, can you please submit the mach-types update yourself? Thank you!
>>>
>> I don't think I'm trusted to do that. I think that some machines may 
>> have been removed
>> from Linux that u-boot may want to keep.
> 
> So these machines have to define their mach id in their config (and you need to fix them after replacing mach-types).
> 
> Since I only want to use the 
>> value in 1 place,
>> is it acceptable to just use the hex value instead?
> 
> No, either update the mach types (preffered) or ... Update the mach types ;)

It was discussed and accepted that the boards can set CONFIG_MACH_TYPE
directly into the configuration file. In this way, we continue to
support in U-Boot boards independently if they are pushed to Linux
mainline or not.

On the other side, everybody can send the current mach-types from the
Linux kernel to Albert (ARM Maintainer) - if a board is already in
kernel mainline is the preferred way.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================