[U-Boot] [PATCH v6] mx6: Read silicon revision from register

[Stefano Babic <sbabic@denx.de>]

On 20/03/2012 15:21, Fabio Estevam wrote:
> Instead of hardcoding the mx6 silicon revision, read it in run-time.
> 
> Also, besides the silicon version print the mx6 variant type: quad,dual/solo 
> or solo-lite.
> 
> Tested on a mx6qsabrelite, where it shows:
> 
> CPU:   Freescale i.MX6Q rev1.0 at 792 MHz  
> 
> Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
> ---
> Changes since v5:
> - Avoid duplication of code.  Also tested on a mx51evk board.
> Changes since v4:
> - Distinguish the the CPU print depending on the SoC type (MX5 or MX6)
> Changes since v3:
> - Provide a complete struct for anatop registers
> Changes since v2:
> - Read both chip variant and chip silicon version from anatop
> - Create a struct for accessing the anatop registers
> Changes since v1:
> - Fix typo on Subject
>  arch/arm/cpu/armv7/imx-common/cpu.c      |   24 +++++-
>  arch/arm/cpu/armv7/mx6/soc.c             |    8 ++-
>  arch/arm/include/asm/arch-mx6/imx-regs.h |  142 ++++++++++++++++++++++++++++++
>  3 files changed, 171 insertions(+), 3 deletions(-)
> 

Acked-by: Stefano Babic <sbabic@denx.de>

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================