[U-Boot] [PATCH v6] mx6: Read silicon revision from register

[Stefano Babic <sbabic@denx.de>]

On 22/03/2012 08:48, Dirk Behme wrote:
> On 21.03.2012 09:41, Stefano Babic wrote:
>> On 20/03/2012 15:21, Fabio Estevam wrote:
>>> Instead of hardcoding the mx6 silicon revision, read it in run-time.
>>>
>>> Also, besides the silicon version print the mx6 variant type:
>>> quad,dual/solo or solo-lite.
>>>
>>> Tested on a mx6qsabrelite, where it shows:
>>>
>>> CPU:   Freescale i.MX6Q rev1.0 at 792 MHz 
>>> Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
>>> ---
>>
>> Applied to u-boot-imx, thanks.
> 
> Thanks!
> 
> Sounds like this
> 
> http://patchwork.ozlabs.org/patch/147669/

It is already acked, I leave always some days for later comments before
applying a patch - sure, it will be applied, too.

Best regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================