[U-Boot] [PATCH] NAND: TI: fix warnings in omap_gpmc.c

[Stefano Babic <sbabic@denx.de>]

On 21/03/2012 19:42, Scott Wood wrote:
> On 03/21/2012 06:33 AM, Stefano Babic wrote:
>> The following warnings are reported for boards using SOFT ECC.
>>
>> omap_gpmc.c:33:30: warning: 'hw_nand_oob' defined but not used
>> omap_gpmc.c:78:13: warning: 'omap_hwecc_init' defined but not used
>> omap_gpmc.c:116:12: warning: 'omap_correct_data' defined but not used
>> omap_gpmc.c:182:12: warning: 'omap_calculate_ecc' defined but not used
>> omap_gpmc.c:208:13: warning: 'omap_enable_hwecc' defined but not used
>>
>> Signed-off-by: Stefano Babic <sbabic@denx.de>
>> Cc: Tom Rini <trini@ti.com>
>> Cc: Scott Wood <scottwood@freescale.com>
>> ---
>>  drivers/mtd/nand/omap_gpmc.c |    6 ++++++
>>  1 files changed, 6 insertions(+), 0 deletions(-)
>>
>> diff --git a/drivers/mtd/nand/omap_gpmc.c b/drivers/mtd/nand/omap_gpmc.c
>> index 1dfe074..3a9baff 100644
>> --- a/drivers/mtd/nand/omap_gpmc.c
>> +++ b/drivers/mtd/nand/omap_gpmc.c
>> @@ -30,7 +30,10 @@
>>  #include <nand.h>
>>  
>>  static uint8_t cs;
>> +#if !defined(CONFIG_SPL_BUILD) || \
>> +	(defined(CONFIG_SPL_BUILD) && !defined(CONFIG_SPL_NAND_SOFTECC))
>>  static struct nand_ecclayout hw_nand_oob = GPMC_NAND_HW_ECC_LAYOUT;
>> +#endif
>>  
>>  /*
>>   * omap_nand_hwcontrol - Set the address pointers corretly for the
>> @@ -69,6 +72,8 @@ int omap_spl_dev_ready(struct mtd_info *mtd)
>>  }
>>  #endif
>>  
>> +#if !defined(CONFIG_SPL_BUILD) || \
>> +	(defined(CONFIG_SPL_BUILD) && !defined(CONFIG_SPL_NAND_SOFTECC))
>>  /*
>>   * omap_hwecc_init - Initialize the Hardware ECC for NAND flash in
>>   *                   GPMC controller
>> @@ -231,6 +236,7 @@ static void omap_enable_hwecc(struct mtd_info *mtd, int32_t mode)
>>  		break;
>>  	}
>>  }
>> +#endif
>>  
>>  #ifndef CONFIG_SPL_BUILD
>>  /*
> 
> Maybe just use __attribute__((unused))?

Of yourse, you are right. We have already the macro __maybe_unused, I
will use it !

Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================