[U-Boot] [PATCH 1/2] FSL/eSDHC: enable the peripheral clock to detect the card

[Stefano Babic <sbabic@denx.de>]

On 27/03/2012 12:25, Chang-Ming.Huang at freescale.com wrote:
> From: Jerry Huang <Chang-Ming.Huang@freescale.com>
> 
> According to the card detection of p1/p2 paltform RM,
> we should set SYSCTL[PEREN] to enable the clock.
> Otherwise, after booting the u-boot, and then inserting the SD card,
> the SD card can't be detected.
> 
> Signed-off-by: Jerry Huang <Chang-Ming.Huang@freescale.com>
> CC: Andy Fleming <afleming@gmail.com>
> ---

Hi Jerry,

>  drivers/mmc/fsl_esdhc.c |    2 ++
>  1 files changed, 2 insertions(+), 0 deletions(-)
> 
> diff --git a/drivers/mmc/fsl_esdhc.c b/drivers/mmc/fsl_esdhc.c
> index a2f35e3..1682a79 100644
> --- a/drivers/mmc/fsl_esdhc.c
> +++ b/drivers/mmc/fsl_esdhc.c
> @@ -491,6 +491,8 @@ int fsl_esdhc_initialize(bd_t *bis, struct fsl_esdhc_cfg *cfg)
>  	/* First reset the eSDHC controller */
>  	esdhc_reset(regs);
>  
> +	esdhc_write32(&regs->sysctl, SYSCTL_PEREN);
> +

You add this setup to all architectures: PQIII, i.MX5, i.MX6. Is it what
you really want ?

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================