[U-Boot] [PATCH v2 1/3] mmc: sdhci: fix the wrong operation when response type is R1b

[Jaehoon Chung <jh80.chung@samsung.com>]

When response type is R1b, mask value is added the SDHCI_INT_DAT_END.
but in while(), didn't check that flag.
So sdhci controller didn't work fine.
CMD6 didn't always complete.

Signed-off-by: Jaehoon Chung <jh80.chung@samsung.com>
Signed-off-by: Kyungmin Park <kyungmin.park@samsung.com>
---
 drivers/mmc/sdhci.c |   33 +++++++++++++++++++++++----------
 1 files changed, 23 insertions(+), 10 deletions(-)

diff --git a/drivers/mmc/sdhci.c b/drivers/mmc/sdhci.c
index fc904b5..0dd08b9 100644
--- a/drivers/mmc/sdhci.c
+++ b/drivers/mmc/sdhci.c
@@ -124,10 +124,11 @@ int sdhci_send_command(struct mmc *mmc, struct mmc_cmd *cmd,
 {
 	struct sdhci_host *host = (struct sdhci_host *)mmc->priv;
 	unsigned int stat = 0;
-	int ret = 0;
+	int i, ret = 0;
 	int trans_bytes = 0, is_aligned = 1;
 	u32 mask, flags, mode;
 	unsigned int timeout, start_addr = 0;
+	unsigned int retry = 10000;
 
 	/* Wait max 10 ms */
 	timeout = 10;
@@ -206,19 +207,31 @@ int sdhci_send_command(struct mmc *mmc, struct mmc_cmd *cmd,
 	flush_cache(start_addr, trans_bytes);
 #endif
 	sdhci_writew(host, SDHCI_MAKE_CMD(cmd->cmdidx, flags), SDHCI_COMMAND);
-	do {
+
+	for (i = 0; i < retry; i++) {
 		stat = sdhci_readl(host, SDHCI_INT_STATUS);
-		if (stat & SDHCI_INT_ERROR)
+		if (stat & (SDHCI_INT_RESPONSE | SDHCI_INT_DATA_END)) {
+			sdhci_cmd_done(host, cmd);
+			sdhci_writel(host, mask, SDHCI_INT_STATUS);
+			if (!data) {
+				sdhci_writel(host, stat,  SDHCI_INT_STATUS);
+			}
 			break;
-	} while ((stat & mask) != mask);
+		}
+	}
 
-	if ((stat & (SDHCI_INT_ERROR | mask)) == mask) {
-		sdhci_cmd_done(host, cmd);
-		sdhci_writel(host, mask, SDHCI_INT_STATUS);
-	} else
-		ret = -1;
+	if (i == retry) {
+		printf("%s: waiting for status update\n",__func__);
+		return TIMEOUT;
+	}
+
+	if (stat & SDHCI_INT_TIMEOUT) {
+		return TIMEOUT;
+	} else if (stat & SDHCI_INT_ERROR) {
+		return -1;
+	}
 
-	if (!ret && data)
+	if (data)
 		ret = sdhci_transfer_data(host, data, start_addr);
 
 	stat = sdhci_readl(host, SDHCI_INT_STATUS);