From mboxrd@z Thu Jan  1 00:00:00 1970
From: Stefano Babic <sbabic@denx.de>
Date: Sun, 06 May 2012 18:42:17 +0200
Subject: [U-Boot] [PATCH] mx28evk: add NAND support
In-Reply-To: <1334658946-7533-1-git-send-email-lauri.hintsala@bluegiga.com>
References: <1334658946-7533-1-git-send-email-lauri.hintsala@bluegiga.com>
Message-ID: <4FA6A9E9.1050906@denx.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

On 17/04/2012 12:35, Lauri Hintsala wrote:
> NAND support is not enabled by default because Eval Kit is not delivered
> with NAND chip. To enable NAND support add CONFIG_CMD_NAND to board config.
> 
> Signed-off-by: Lauri Hintsala <lauri.hintsala@bluegiga.com>
> ---

Applied to u-boot-imx, thanks

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================