[U-Boot] [PATCH] NAND: Remove ONFI detection message to from bootup log

[Amit Virdi <amit.virdi@st.com>]

Stefan,

On 5/8/2012 12:59 PM, Stefan Roese wrote:
> Without this patch, boot shows this messages upon NAND detection:
>
> NAND:  ONFI flash detected
> ONFI param page 0 valid
> ONFI flash detected
> ONFI param page 0 valid
> 128 MiB
>
> With this patch, its back to the U-Boot "standard":
>
> NAND:  128 MiB
>
> Tested on x600 (SPEAr600).
>
> Signed-off-by: Stefan Roese<sr@denx.de>
> Cc: Amit Virdi<amit.virdi@st.com>
> Cc: Vipin Kumar<vipin.kumar@st.com>
> Cc: Scott Wood<scottwood@freescale.com>
> ---
>   drivers/mtd/nand/nand_base.c |    5 +++--
>   1 file changed, 3 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/mtd/nand/nand_base.c b/drivers/mtd/nand/nand_base.c
> index bef79be..bfd668f 100644
> --- a/drivers/mtd/nand/nand_base.c
> +++ b/drivers/mtd/nand/nand_base.c
> @@ -2530,13 +2530,14 @@ static int nand_flash_detect_onfi(struct mtd_info *mtd, struct nand_chip *chip,
>   		chip->read_byte(mtd) != 'F' || chip->read_byte(mtd) != 'I')
>   		return 0;
>
> -	printk(KERN_INFO "ONFI flash detected\n");
> +	MTDDEBUG(MTD_DEBUG_LEVEL0, "ONFI flash detected\n");
>   	chip->cmdfunc(mtd, NAND_CMD_PARAM, 0, -1);
>   	for (i = 0; i<  3; i++) {
>   		chip->read_buf(mtd, (uint8_t *)p, sizeof(*p));
>   		if (onfi_crc16(ONFI_CRC_BASE, (uint8_t *)p, 254) ==
>   				le16_to_cpu(p->crc)) {
> -			printk(KERN_INFO "ONFI param page %d valid\n", i);
> +			MTDDEBUG(MTD_DEBUG_LEVEL0,
> +				 "ONFI param page %d valid\n", i);
>   			break;
>   		}
>   	}

Acked-by: Amit Virdi <amit.virdi@st.com>

Regards
Amit Virdi