[U-Boot] [PATCH] ATMEL/PIO: Enable new feature of PIO on Atmel device

[Bo Shen <voice.shen@atmel.com>]

On 5/14/2012 23:36, Andreas Bie?mann wrote:
> Dear Bo Shen,
>
> On 14.05.2012 11:00, Bo Shen wrote:
>> Enable new PIO feature supported by Atmel SoC.
>> Using CPU_HAS_PIO3 micro to enable PIO new feature.
>>
>> Signed-off-by: Bo Shen<voice.shen@atmel.com>
>> ---
>>   arch/arm/include/asm/arch-at91/at91_pio.h |   71 ++++++++++++++++-
>>   drivers/gpio/at91_gpio.c                  |  123 ++++++++++++++++++++++++++++-
>>   2 files changed, 191 insertions(+), 3 deletions(-)
>>
>> diff --git a/arch/arm/include/asm/arch-at91/at91_pio.h b/arch/arm/include/asm/arch-at91/at91_pio.h
>> index 416cabf..4ceedee 100644
>> --- a/arch/arm/include/asm/arch-at91/at91_pio.h
>> +++ b/arch/arm/include/asm/arch-at91/at91_pio.h
> <snip>
>
>> @@ -137,11 +180,37 @@ int at91_get_pio_value(unsigned port, unsigned pin);
>>   #define PIO_PUER	0x64	/* Pull-up Enable Register */
>>   #define PIO_PUSR	0x68	/* Pull-up Status Register */
>>   #define PIO_ASR		0x70	/* Peripheral A Select Register */
>> +#define PIO_ABCDSR1	0x70	/* Peripheral ABCD Select Register 1 */
>>   #define PIO_BSR		0x74	/* Peripheral B Select Register */
>> +#define PIO_ABCDSR2	0x74	/* Peripheral ABCD Select Register 2 */
>>   #define PIO_ABSR	0x78	/* AB Status Register */
>> +#define PIO_IFSCDR	0x80	/* Input Filter Slow Clock Disable Register */
>> +#define PIO_IFSCER	0x84	/* Input Filter Slow Clock Enable Register */
>> +#define PIO_IFSCSR	0x88	/* Input Filter Slow Clock Status Register */
>> +#define PIO_SCDR	0x8c	/* Slow Clock Divider Debouncing Register */
>> +#define		PIO_SCDR_DIV	(0x3fff<<   0)	/* Slow Clock Divider Mask */
>> +#define PIO_PPDDR	0x90	/* Pad Pull-down Disable Register */
>> +#define PIO_PPDER	0x94	/* Pad Pull-down Enable Register */
>> +#define PIO_PPDSR	0x98	/* Pad Pull-down Status Register */
>>   #define PIO_OWER	0xa0	/* Output Write Enable Register */
>>   #define PIO_OWDR	0xa4	/* Output Write Disable Register */
>>   #define PIO_OWSR	0xa8	/* Output Write Status Register */
>> +#define PIO_AIMER	0xb0	/* Additional INT Modes Enable Register */
>> +#define PIO_AIMDR	0xb4	/* Additional INT Modes Disable Register */
>> +#define PIO_AIMMR	0xb8	/* Additional INT Modes Mask Register */
>> +#define PIO_ESR		0xc0	/* Edge Select Register */
>> +#define PIO_LSR		0xc4	/* Level Select Register */
>> +#define PIO_ELSR	0xc8	/* Edge/Level Status Register */
>> +#define PIO_FELLSR	0xd0	/* Falling Edge/Low Level Select Register */
>> +#define PIO_REHLSR	0xd4	/* Rising Edge/ High Level Select Register */
>> +#define PIO_FRLHSR	0xd8	/* Fall/Rise - Low/High Status Register */
>> +#define PIO_SCHMITT	0x100	/* Schmitt Trigger Register */
>> +
>> +#define ABCDSR_PERIPH_A	0x0
>> +#define ABCDSR_PERIPH_B	0x1
>> +#define ABCDSR_PERIPH_C	0x2
>> +#define ABCDSR_PERIPH_D	0x3
>> +
>>   #endif
>>
>>   #endif
> shouldn't we drop the legacy interface completely instead of adding new
> definitions?

OK. I will deal with this. Thanks.

>
> <snip>
>
> best regards
>
> Andreas Bie?mann
>