[U-Boot] [PATCH] i.MX28: Add function to adjust memory parameters

[Stefano Babic <sbabic@denx.de>]

On 18/06/2012 16:23, Marek Vasut wrote:
> Dear Fabio Estevam,
> 
>> Hi Marek,
>>
>> On Thu, May 31, 2012 at 3:45 PM, Marek Vasut <marex@denx.de> wrote:
>>> Call this or similar in your spl_boot.c to adjust the DRAM configuration.
>>> Actually I think even the following value should fix your problem:
>>>
>>> void mx28_adjust_memory_params(uint32_t *dram_vals)
>>> {
>>>        dram_vals[0x74 >> 2] = 0x0f02010a;
>>> }
>>
>> I finally had a chance to try this and my mx28evk can boot again with
>> your patch + the code above.
>>
>> How do we handle this? Would you send a v2 with this additional code
>> or should I do it myself after your original patch in this thread gets
>> applied?
> 
> Stefano, can you please apply this? So Fabio can apply his on top of it?

I do it.
> 
>> Also, please explain to the mortal folks what 'dram_vals[0x74 >> 2] =
>> 0x0f02010a;' means.
> 
> Well, check that particular register (memory configuration register at +0x74 
> offset) in the datasheet. It's basically adjusting the number of enabled address 
> row and columns.
> 
>> It is not something very trivial to figure out :-)
> 
> It actually is, see above ;-)

I see, but I will never apply a patch programmed in hexadecimal instead
of plain C ;-)

Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================