From mboxrd@z Thu Jan 1 00:00:00 1970 From: Bill Date: Fri, 27 Jul 2012 08:07:40 -0500 Subject: [U-Boot] Building u-boot for iMX28 and getting error in mkimage of missing command line parameter CONFIG_IMX_CONFIG In-Reply-To: References: <50118C35.4040304@techsi.com> Message-ID: <5012929C.9000905@techsi.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Thanks. That did it! However, now my new U-boot built from the mainstream Uboot runs and also loads and unpacks the Linux kernel - but it dies after that. However, my original U-boot from tlib works fine. Are there some patches and/or settings I am missing? Thanks, Bills On 7/26/2012 3:24 PM, Fabio Estevam wrote: > Bill, > > On Thu, Jul 26, 2012 at 3:28 PM, Bill wrote: >> All, >> >> I am working on building the latest u-boot for the imx28evk board. I >> have done the following steps: >> >> 1. git clone git://git.denx.de/u-boot-imx.git >> 2. setup paths for finding my cross-compiler >> 1. make mx28evk_config >> 2. make u-boot.imx > 'make u-boot.imx' is not correct for mx28. > > You should do: > > make u-boot.sb > > Please follow the instructions at doc/README.mx28_common for the > correct process. > > Regards, > > Fabio Estevam -- William (Bill) L. Sousan, Ph.D. (w) 402.331.4977 ext. 4002 bsousan at techsi.com Technical Support Inc. 11253 John Galt Blvd Omaha, NE 68137 www.techsi.com 8(a) SDB Certified, ISO 9001:2008