From mboxrd@z Thu Jan 1 00:00:00 1970 From: Bill Date: Fri, 27 Jul 2012 10:35:45 -0500 Subject: [U-Boot] Building u-boot for iMX28 and getting error in mkimage of missing command line parameter CONFIG_IMX_CONFIG In-Reply-To: References: <50118C35.4040304@techsi.com> <5012929C.9000905@techsi.com> Message-ID: <5012B551.8000603@techsi.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Thanks. I tried that and got the same results. Are there any debug/logging that I can use to see what's going on? Also, I'm not sure which console parameters are passed to the kernel. I've seen console, console_mainline, console_fsl, etc... Which one is actually passed as command line params to the kernel? Thanks, Bill On 7/27/2012 8:11 AM, Fabio Estevam wrote: > Bill, > > On Fri, Jul 27, 2012 at 10:07 AM, Bill wrote: >> Thanks. That did it! >> >> >> However, now my new U-boot built from the mainstream Uboot runs and also >> loads and unpacks the Linux kernel - but it dies after that. However, my >> original U-boot from tlib works fine. Are there some patches and/or >> settings I am missing? > I suppose you are using the 2.6.35 kernel. In this FSL kernel the > console is ttyAM0. > > In mainline kernel the console is ttyAMA0. > > This is probably the reason you don't see nothing in the console. > > I would suggest you to use the mainline kernel though. > > Regards, > > Fabio Estevam -- William (Bill) L. Sousan, Ph.D. (w) 402.331.4977 ext. 4002 bsousan at techsi.com Technical Support Inc. 11253 John Galt Blvd Omaha, NE 68137 www.techsi.com 8(a) SDB Certified, ISO 9001:2008