[U-Boot] [PATCH 2/4] efikamx: remove drive strength hack from early_init_f and move it to the DCD

[stefano babic <sbabic@denx.de>]

Am 19/08/2012 00:29, schrieb Marek Vasut:
> Dear Matt Sealey,
> 
>> On Sat, Aug 18, 2012 at 10:34 AM, Stefano Babic <sbabic@denx.de> wrote:
>>> On 17/08/2012 20:19, Matt Sealey wrote:
>>>> The i.MX Boot ROM lets us set up certain registers before U-Boot even
>>>> gets executed. Rather than setting up DDR, putting U-Boot in place, and
>>>> getting into pre-relocation init to set up DDR again, just do it once
>>>> in the correct place. This also solves an issue where the Smarttop DDR
>>>> pad settings were being applied on Smartbook.
>>>>
>>>> While we're at it, configure PCBID0,1,2 and the LED GPIO since we've
>>>> still got room in the DCD to do so.
>>>>
>>>> Signed-off-by: Matt Sealey <matt@genesi-usa.com>
>>>> ---
>>>
>>> Hi Matt,
>>>
>>>> diff --git a/board/genesi/mx51_efikamx/imximage_mx.cfg
>>>> b/board/genesi/mx51_efikamx/imximage_mx.cfg index 6fe0ff9..ac9aa9a
>>>> 100644
>>>> --- a/board/genesi/mx51_efikamx/imximage_mx.cfg
>>>> +++ b/board/genesi/mx51_efikamx/imximage_mx.cfg
>>>> @@ -1,7 +1,7 @@
>>>>
>>>>  #
>>>>
>>>> +# Copyright (C) 2009 Pegatron Corporation
>>>>
>>>                     ^---
>>>
>>> Was this added for mistake ? I think you should add only yours.
>>
>> The drive strength settings came from Pegatron a long, long time ago
>> (2009 :) and our old config and the function is copyrighted to them.
>> Just because Marek took them out and recopyrighted the file I derived
>> them from in this case doesn't mean they lost their copyright..
> 
> This file was taken from mx51evk. It's written there. Please stop this nonsense, 
> it's troubling me.

Then Pegatron has nothing to do with it. The original comes from
Freescale, and the copyright was set.

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================