[U-Boot] [PATCH 2/2] imx27lite: update with gpio api change (v4)

[Stefano Babic <sbabic@denx.de>]

On 25/08/2012 17:30, Philippe Reynes wrote:
> Signed-off-by: Philippe Reynes <tremyfr@yahoo.fr>
> ---
>  board/logicpd/imx27lite/imx27lite.c |    5 ++---
>  include/configs/imx27lite-common.h  |    5 +++++
>  2 files changed, 7 insertions(+), 3 deletions(-)
> 
> diff --git a/board/logicpd/imx27lite/imx27lite.c b/board/logicpd/imx27lite/imx27lite.c
> index 8a5015c..b38e5ab 100644
> --- a/board/logicpd/imx27lite/imx27lite.c
> +++ b/board/logicpd/imx27lite/imx27lite.c
> @@ -23,12 +23,12 @@
>  #include <common.h>
>  #include <asm/io.h>
>  #include <asm/arch/imx-regs.h>
> +#include <asm/gpio.h>
>  
>  DECLARE_GLOBAL_DATA_PTR;
>  
>  int board_init(void)
>  {
> -	struct gpio_regs *regs = (struct gpio_regs *)IMX_GPIO_BASE;
>  #if defined(CONFIG_SYS_NAND_LARGEPAGE)
>  	struct system_control_regs *sc_regs =
>  		(struct system_control_regs *)IMX_SYSTEM_CTL_BASE;
> @@ -43,8 +43,7 @@ int board_init(void)
>  #ifdef CONFIG_FEC_MXC
>  	mx27_fec_init_pins();
>  	imx_gpio_mode((GPIO_PORTC | GPIO_OUT | GPIO_PUEN | GPIO_GPIO | 31));
> -	writel(readl(&regs->port[PORTC].dr) | (1 << 31),
> -				&regs->port[PORTC].dr);
> +	gpio_set_value(GPIO_PORTC | 31, 1);
>  #endif
>  #ifdef CONFIG_MXC_MMC
>  #if defined(CONFIG_MAGNESIUM)
> diff --git a/include/configs/imx27lite-common.h b/include/configs/imx27lite-common.h
> index 7d2876b..2e79a9e 100644
> --- a/include/configs/imx27lite-common.h
> +++ b/include/configs/imx27lite-common.h
> @@ -162,6 +162,11 @@
>  #define CONFIG_DOS_PARTITION
>  
>  /*
> + * GPIO
> + */
> +#define CONFIG_MXC_GPIO
> +
> +/*
>   * MTD partitions
>   */
>  #define CONFIG_CMD_MTDPARTS
> 

Acked-by: Stefano Babic <sbabic@denx.de>

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================