[U-Boot] [PATCH 3/4] efikamx: configure Smarttop PCBID and LED pads in DCD for convenience

[Stefano Babic <sbabic@denx.de>]

On 22/08/2012 21:25, Matt Sealey wrote:
> PCBID pads seem to need time to settle due to external pulldowns, otherwise
> we are reading floating GPIO pins with implicit pad pullups and get the wrong
> data. However we can't "wait" at the time we need them before relocation,
> since timers are not available. The time taken to get from DCD to the code
> requiring the pads set seems to be more than long enough (even with caches
> enabled).
> 
> We have space in the DCD due to the DDR settings changes to configure all
> the pad settings we need for this, plus the LED pad settings too which
> reduces the amount of code required later on.
> 
> Signed-off-by: Matt Sealey <matt@genesi-usa.com>
> ---

Applied to u-boot-imx, thanks.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================