[U-Boot] [v3] arm: Fixed the offset for the no relocation.

[Stefano Babic <sbabic@denx.de>]

On 05/09/2012 16:45, Zhong Hongbo wrote:
> On 04/09/12 23:57, Stefano Babic wrote:
>> On 04/09/2012 16:03, Zhong Hongbo wrote:
>>> On 03/09/12 08:14, Marek Vasut wrote:
>>>> Dear Zhong Hongbo,
>>>>
>>>>> From: Zhong Hongbo <bocui107@gmail.com>
>>>>>
>>>>> When the u-boot address of destination equal to  __start,
>>>>> no relocation. relocation offset(r9) = 0.
>>>>
>>>> Good, now what kind of issue does this patch fix?
>>> Hi Marek
>>>
>>> When you adopt CONFIG_SPL_BUILD framework, no CONFIG_NAND_SPL, if the
>>> addr of destination is equal to _start, we should skip u-boot relocation.
>>>
>>> In the last, u-boot will count the dest addr, see the below:
>>>
>>>
>>>         adr     r1, _start
>>>         add     lr, r0, r1
>>>         add     lr, lr, r9
>>>
>>> Here, lr = lr + r9, r9 is the offset of u-boot, So when it do not neet
>>> to reolocat, we need to set the zero value for r9 register.
>>>
>>>         /* setup parameters for board_init_r */
>>>         mov     r0, r5          /* gd_t */
>>>         mov     r1, r6          /* dest_addr */
>>>         /* jump to it ... */
>>>         mov     pc, lr
>>
>> I can confirm this issue - I see this when I ported SPL to a MX35 board.
>> However, clearing r9 was not enough. I had to fix also _rel_dyn_* to
>> make SPL working, and I did changing the start.S in the same way start.S
>> for arv7 is built.
>>
>> Do you not have these issues ?
> Hi Stefano,
> 
> That is enough for my smdk6400 board.


Ok, thanks. Then I will post a patch on top of yours, but here my:

Tested-by: Stefano Babic <sbabic@denx.de>

Tested on a i.MX35 board (ARM1136) with SPL.

Regards,
Stefano


-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================