From mboxrd@z Thu Jan  1 00:00:00 1970
From: stefano babic <sbabic@denx.de>
Date: Thu, 13 Sep 2012 09:48:33 +0200
Subject: [U-Boot] Help Required [imx35pdk]
In-Reply-To: <CAOMZO5D3F0bujqVb_XcLRCn73UhTYUAgVg8ttapNJ8hK2Y=ahA@mail.gmail.com>
References: <CAHjRDdjM7tYnFd8d_ena2sUXcooav-2Hw-9o_A1M=-ZfxN8eQQ@mail.gmail.com>
	<201209122307.20680.marex@denx.de> <5051022F.2090700@denx.de>
	<CAOMZO5D3F0bujqVb_XcLRCn73UhTYUAgVg8ttapNJ8hK2Y=ahA@mail.gmail.com>
Message-ID: <50518FD1.5030105@denx.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Am 13/09/2012 06:55, schrieb Fabio Estevam:
> Hi Stefano,
> 
> On Wed, Sep 12, 2012 at 6:44 PM, stefano babic <sbabic@denx.de> wrote:
> 
>> U-Boot for mx35pdk runs from NOR and not from NAND. There is no support
>> to run from NAND. Even if I can "convince" the board to boot from NAND,
>> this was not pushed to mainline. I explain why.
> 
> Reading board/freescale/mx35pdk/README it gives the impression that
> booting from NAND is supported.

It is a wrong impression, it is not (yet) supported..

> 
> Should this be updated?

Yes !

Regards,
Stefano


-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================