[U-Boot] [PATCH 1/6] h2200: Add support for iPAQ h2200

["Łukasz Dałek" <luk0104@gmail.com>]

On 22.09.2012 19:04, Marek Vasut wrote:
> Dear ?ukasz Da?ek,
>
>> On 19.09.2012 23:02, Marek Vasut wrote:
>>>> and at the offset
>>>> + * 0x40 ascii characters 'ECEC', secondly 1st stage
>>>> + * loads code from flash into SDRAM at address 0xa0040000
>>>> + * so all instructions which reinitializes memory
>>>> + * controller have to be disabled.
>>>> + */
>>>> +
>>>> +static inline void writelrb(uint32_t val, uint32_t addr)
>>> Replace this with clrsetbits_le32()
>> I've copied writelrb and pxa2xx_dram_init from pxa2xx.c
>> and I think there is a reason why it's done that way and not by
>> clrsetbits_le32. But if you insist I can replace all calls to writelrb
>> by clrsetbits.
> And can you elaborate on the reason please?
>
> (hint: clrsetbits() wasn't there by the time)

I don't know what was the reason. I didn't change becuse I didn't
want to break it.

>>>> +{
>>>> +	writel(val, addr);
>>>> +	asm volatile("" : : : "memory");
>>>> +	readl(addr);
>>>> +	asm volatile("" : : : "memory");
>>>> +}
>>>> +
>>>> +static void h2200_pxa2xx_dram_init(void)
>>> Why do you duplicate it ?!
>>>
>>> [...]
>> Because code in pxa2xx.c disable and then re-enable memory.
>> And u-boot is executed from memory (1st stage bootloder
>> copied it there).
> So don't reinit the memory at all, just skip this whole part.

1st stage loader doesn't init everything (for example MSC).

>>> +
>>> +# define CONFIG_USB_ETHER		1
>>> +# define CONFIG_USBNET_DEV_ADDR		"de:ad:be:ef:00:01"
>>> +# define CONFIG_USBNET_HOST_ADDR	"de:ad:be:ef:00:02"
>>> Definitelly not, any mac address setting should not be present, Joe ?
>> So tell me how should I specify mac addresses? By EXTRA_ENV_SETTINGS?
> Joe explained it, your adapter doesn't carry it's own mac?

No.

?ukasz Da?ek