[U-Boot] [PATCH v2 0/3] Enable MMC support for at91sam9x5ek board.

[Josh Wu <josh.wu@atmel.com>]

Hi, Andreas

On 10/10/2012 5:51 AM, Andreas Bie?mann wrote:
> Hi Josh,
>
> On 09.10.12 12:11, Josh Wu wrote:
>> Hi, Andreas
>>
>> Any feedback of these patches?
> short answer: no ;)
>
> I think they could go into next (no obvious objections), but I would
> like to do some runtime tests on avr32 before. Beside that, if you do
> not insist on applying them ASAP to next I would like to wait until the
> release next Monday and apply the patches to u-boot-atmel/master then.
> Is that OK for you?

Yes, I'm fine with this. thank you.

Best Regards,
Josh Wu

>
> Best regards
>
> Andreas Bie?mann
>
>> Best Regards,
>> Josh Wu
>>
>> On 9/14/2012 4:22 PM, Josh Wu wrote:
>>> This patch series enable MCI0 solt in at91sam9x5ek board.
>>>
>>> Josh Wu (3):
>>>     mmc: at91: add multi block read/write support.
>>>     ARM: at91sam9x5: enable MCI0 support for 9x5ek board.
>>>     mmc: at91: use max timeout value. It will avoid some situation that
>>>       timeout happened.
>>>
>>>    arch/arm/cpu/arm926ejs/at91/at91sam9x5_devices.c |   15 +++++++++++++++
>>>    board/atmel/at91sam9x5ek/at91sam9x5ek.c          |   10 ++++++++++
>>>    drivers/mmc/gen_atmel_mci.c                      |   15 +++++++++++++--
>>>    include/atmel_mci.h                              |    7 ++++++-
>>>    include/configs/at91sam9x5ek.h                   |   10 ++++++++++
>>>    5 files changed, 54 insertions(+), 3 deletions(-)
>>>