From mboxrd@z Thu Jan 1 00:00:00 1970 From: Eric Nelson Date: Thu, 25 Oct 2012 08:44:08 -0700 Subject: [U-Boot] mx6qsabrelite: commands not recognized In-Reply-To: <508947AA.8020100@boundarydevices.com> References: <508947AA.8020100@boundarydevices.com> Message-ID: <50895E48.6020004@boundarydevices.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi Fabio, On 10/25/2012 07:07 AM, Eric Nelson wrote: > Hi Fabio, > > On 10/25/2012 06:28 AM, Fabio Estevam wrote: >> Hi, >> >> Using the latest u-boot-imx tree, I am getting the following on a mx6qsabrelite: >> >> U-Boot 2012.10-09478-gab857f2 (Oct 25 2012 - 11:24:04) >> >> >> >> Hit any key to stop autoboot: 0 >> MX6QSABRELITE U-Boot> save >> Unknown command 'save' - try 'help' >> MX6QSABRELITE U-Boot> >> >> Basically no commands are recognized. >> >> Haven't started bisecting this yet, but just wanted to check if others >> see the same issue. >> > > You might want to check how you're programming this. > > I saw this issue when U-Boot first went above 256k (the SPI-NOR > upgrade script only erased 0x40000 bytes). > > I'll test later today. > Worked for me... U-Boot 2012.10-01993-gab857f2 (Oct 25 2012 - 08:00:14) CPU: Freescale i.MX6Q rev1.0 at 792 MHz Reset cause: POR Board: MX6Q-Sabre Lite DRAM: 1 GiB MMC: FSL_SDHC: 0, FSL_SDHC: 1 *** Warning - bad CRC, using default environment auto-detected panel HDMI enable_hdmi: setup HDMI monitor Display: HDMI (1024x768) In: serial Out: serial Err: serial Net: FEC [PRIME] Warning: FEC using MAC address from net device Hit any key to stop autoboot: 0 MX6QSABRELITE U-Boot > MX6QSABRELITE U-Boot > help ? - alias for 'help' base - print or set address offset bdinfo - print Board Info structure