[U-Boot] mx6qsabrelite: commands not recognized

Eric Nelson
2012-10-25T15:44:08Z

Hi Fabio,

On 10/25/2012 07:07 AM, Eric Nelson wrote:
> Hi Fabio,
>
> On 10/25/2012 06:28 AM, Fabio Estevam wrote:
>> Hi,
>>
>> Using the latest u-boot-imx tree, I am getting the following on a mx6qsabrelite:
>>
>> U-Boot 2012.10-09478-gab857f2 (Oct 25 2012 - 11:24:04)
>>
>> <snip>
>>
>> Hit any key to stop autoboot: 0
>> MX6QSABRELITE U-Boot> save
>> Unknown command 'save' - try 'help'
>> MX6QSABRELITE U-Boot>
>>
>> Basically no commands are recognized.
>>
>> Haven't started bisecting this yet, but just wanted to check if others
>> see the same issue.
>>
>
> You might want to check how you're programming this.
>
> I saw this issue when U-Boot first went above 256k (the SPI-NOR
> upgrade script only erased 0x40000 bytes).
>
> I'll test later today.
>

Worked for me...

U-Boot 2012.10-01993-gab857f2 (Oct 25 2012 - 08:00:14)

CPU: Freescale i.MX6Q rev1.0 at 792 MHz
Reset cause: POR
Board: MX6Q-Sabre Lite
DRAM: 1 GiB
MMC: FSL_SDHC: 0, FSL_SDHC: 1
*** Warning - bad CRC, using default environment

auto-detected panel HDMI
enable_hdmi: setup HDMI monitor
Display: HDMI (1024x768)
In: serial
Out: serial
Err: serial
Net: FEC [PRIME]
Warning: FEC using MAC address from net device

Hit any key to stop autoboot: 0
MX6QSABRELITE U-Boot >
MX6QSABRELITE U-Boot > help
? - alias for 'help'
base - print or set address offset
bdinfo - print Board Info structure