* [U-Boot] [PATCH] omap: emif: configure emif only when required
@ 2012-11-14 8:49 Lokesh Vutla
2012-11-14 13:32 ` R Sricharan
0 siblings, 1 reply; 3+ messages in thread
From: Lokesh Vutla @ 2012-11-14 8:49 UTC (permalink / raw)
To: u-boot
DMM_LISA_MAP registers program whether memory is mapped
on particular EMIF or not. Irrespective of these registers
EMIF is getting configured. Correcting the same.
Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
---
arch/arm/cpu/armv7/omap-common/emif-common.c | 39 ++++++++++++++++++++++----
1 file changed, 34 insertions(+), 5 deletions(-)
diff --git a/arch/arm/cpu/armv7/omap-common/emif-common.c b/arch/arm/cpu/armv7/omap-common/emif-common.c
index 30dcf1b..179525f 100644
--- a/arch/arm/cpu/armv7/omap-common/emif-common.c
+++ b/arch/arm/cpu/armv7/omap-common/emif-common.c
@@ -33,6 +33,8 @@
#include <asm/utils.h>
#include <linux/compiler.h>
+static int emif1_enabled = -1, emif2_enabled = -1;
+
void set_lpmode_selfrefresh(u32 base)
{
struct emif_reg_struct *emif = (struct emif_reg_struct *)base;
@@ -1218,6 +1220,27 @@ void dmm_init(u32 base)
}
}
+static void enable_emifs(void)
+{
+ u32 i, section, valid;
+
+ emif1_enabled = 0;
+ emif2_enabled = 0;
+ for (i = 0; i < 4; i++) {
+ section = __raw_readl(DMM_BASE + i*4);
+ valid = (section & EMIF_SDRC_MAP_MASK) >>
+ (EMIF_SDRC_MAP_SHIFT);
+ if (valid == 1) {
+ emif1_enabled = 1;
+ } else if (valid == 2) {
+ emif2_enabled = 1;
+ } else if (valid == 3) {
+ emif1_enabled = 1;
+ emif2_enabled = 1;
+ return;
+ }
+ }
+}
/*
* SDRAM initialization:
* SDRAM initialization has two parts:
@@ -1255,15 +1278,21 @@ void sdram_init(void)
writel(CM_DLL_CTRL_NO_OVERRIDE, &prcm->cm_dll_ctrl);
}
- do_sdram_init(EMIF1_BASE);
- do_sdram_init(EMIF2_BASE);
-
if (!in_sdram)
dmm_init(DMM_BASE);
+ enable_emifs();
+ if (emif1_enabled)
+ do_sdram_init(EMIF1_BASE);
+
+ if (emif2_enabled)
+ do_sdram_init(EMIF2_BASE);
+
if (!(in_sdram || warm_reset())) {
- emif_post_init_config(EMIF1_BASE);
- emif_post_init_config(EMIF2_BASE);
+ if (emif1_enabled)
+ emif_post_init_config(EMIF1_BASE);
+ if (emif2_enabled)
+ emif_post_init_config(EMIF2_BASE);
}
/* for the shadow registers to take effect */
--
1.7.9.5
^ permalink raw reply related [flat|nested] 3+ messages in thread
* [U-Boot] [PATCH] omap: emif: configure emif only when required
2012-11-14 8:49 [U-Boot] [PATCH] omap: emif: configure emif only when required Lokesh Vutla
@ 2012-11-14 13:32 ` R Sricharan
2012-11-14 16:44 ` Lokesh Vutla
0 siblings, 1 reply; 3+ messages in thread
From: R Sricharan @ 2012-11-14 13:32 UTC (permalink / raw)
To: u-boot
On Wednesday 14 November 2012 02:19 PM, Lokesh Vutla wrote:
> DMM_LISA_MAP registers program whether memory is mapped
> on particular EMIF or not. Irrespective of these registers
> EMIF is getting configured. Correcting the same.
>
> Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
> ---
> arch/arm/cpu/armv7/omap-common/emif-common.c | 39 ++++++++++++++++++++++----
> 1 file changed, 34 insertions(+), 5 deletions(-)
>
> diff --git a/arch/arm/cpu/armv7/omap-common/emif-common.c b/arch/arm/cpu/armv7/omap-common/emif-common.c
> index 30dcf1b..179525f 100644
> --- a/arch/arm/cpu/armv7/omap-common/emif-common.c
> +++ b/arch/arm/cpu/armv7/omap-common/emif-common.c
> @@ -33,6 +33,8 @@
> #include <asm/utils.h>
> #include <linux/compiler.h>
>
> +static int emif1_enabled = -1, emif2_enabled = -1;
> +
> void set_lpmode_selfrefresh(u32 base)
> {
> struct emif_reg_struct *emif = (struct emif_reg_struct *)base;
> @@ -1218,6 +1220,27 @@ void dmm_init(u32 base)
> }
> }
>
> +static void enable_emifs(void)
> +{
> + u32 i, section, valid;
> +
> + emif1_enabled = 0;
> + emif2_enabled = 0;
> + for (i = 0; i < 4; i++) {
> + section = __raw_readl(DMM_BASE + i*4);
> + valid = (section & EMIF_SDRC_MAP_MASK) >>
> + (EMIF_SDRC_MAP_SHIFT);
> + if (valid == 1) {
> + emif1_enabled = 1;
> + } else if (valid == 2) {
> + emif2_enabled = 1;
> + } else if (valid == 3) {
> + emif1_enabled = 1;
> + emif2_enabled = 1;
> + return;
> + }
> + }
> +}
> /*
> * SDRAM initialization:
> * SDRAM initialization has two parts:
> @@ -1255,15 +1278,21 @@ void sdram_init(void)
> writel(CM_DLL_CTRL_NO_OVERRIDE, &prcm->cm_dll_ctrl);
> }
>
> - do_sdram_init(EMIF1_BASE);
> - do_sdram_init(EMIF2_BASE);
> -
> if (!in_sdram)
> dmm_init(DMM_BASE);
>
> + enable_emifs();
The function name is odd. It has got nothing to do with enabling
EMIF's. It just identifies which is enabled ?. How about
set_enabled_emifs ?
Also this can done just when you are configuring the LISA registers.
That way a extra function is avoided.
Regards,
Sricharan
^ permalink raw reply [flat|nested] 3+ messages in thread
* [U-Boot] [PATCH] omap: emif: configure emif only when required
2012-11-14 13:32 ` R Sricharan
@ 2012-11-14 16:44 ` Lokesh Vutla
0 siblings, 0 replies; 3+ messages in thread
From: Lokesh Vutla @ 2012-11-14 16:44 UTC (permalink / raw)
To: u-boot
On Wednesday 14 November 2012 07:02 PM, R Sricharan wrote:
> On Wednesday 14 November 2012 02:19 PM, Lokesh Vutla wrote:
>> DMM_LISA_MAP registers program whether memory is mapped
>> on particular EMIF or not. Irrespective of these registers
>> EMIF is getting configured. Correcting the same.
>>
>> Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
>> ---
>> arch/arm/cpu/armv7/omap-common/emif-common.c | 39
>> ++++++++++++++++++++++----
>> 1 file changed, 34 insertions(+), 5 deletions(-)
>>
>> diff --git a/arch/arm/cpu/armv7/omap-common/emif-common.c
>> b/arch/arm/cpu/armv7/omap-common/emif-common.c
>> index 30dcf1b..179525f 100644
>> --- a/arch/arm/cpu/armv7/omap-common/emif-common.c
>> +++ b/arch/arm/cpu/armv7/omap-common/emif-common.c
>> @@ -33,6 +33,8 @@
>> #include <asm/utils.h>
>> #include <linux/compiler.h>
>>
>> +static int emif1_enabled = -1, emif2_enabled = -1;
>> +
>> void set_lpmode_selfrefresh(u32 base)
>> {
>> struct emif_reg_struct *emif = (struct emif_reg_struct *)base;
>> @@ -1218,6 +1220,27 @@ void dmm_init(u32 base)
>> }
>> }
>>
>> +static void enable_emifs(void)
>> +{
>> + u32 i, section, valid;
>> +
>> + emif1_enabled = 0;
>> + emif2_enabled = 0;
>> + for (i = 0; i < 4; i++) {
>> + section = __raw_readl(DMM_BASE + i*4);
>> + valid = (section & EMIF_SDRC_MAP_MASK) >>
>> + (EMIF_SDRC_MAP_SHIFT);
>> + if (valid == 1) {
>> + emif1_enabled = 1;
>> + } else if (valid == 2) {
>> + emif2_enabled = 1;
>> + } else if (valid == 3) {
>> + emif1_enabled = 1;
>> + emif2_enabled = 1;
>> + return;
>> + }
>> + }
>> +}
>> /*
>> * SDRAM initialization:
>> * SDRAM initialization has two parts:
>> @@ -1255,15 +1278,21 @@ void sdram_init(void)
>> writel(CM_DLL_CTRL_NO_OVERRIDE, &prcm->cm_dll_ctrl);
>> }
>>
>> - do_sdram_init(EMIF1_BASE);
>> - do_sdram_init(EMIF2_BASE);
>> -
>> if (!in_sdram)
>> dmm_init(DMM_BASE);
>>
>> + enable_emifs();
> The function name is odd. It has got nothing to do with enabling
> EMIF's. It just identifies which is enabled ?. How about
> set_enabled_emifs ?
>
> Also this can done just when you are configuring the LISA registers.
> That way a extra function is avoided.
Yes you are right. Ill do this post it.
Thanks
Lokesh
>
> Regards,
> Sricharan
^ permalink raw reply [flat|nested] 3+ messages in thread
end of thread, other threads:[~2012-11-14 16:44 UTC | newest]
Thread overview: 3+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2012-11-14 8:49 [U-Boot] [PATCH] omap: emif: configure emif only when required Lokesh Vutla
2012-11-14 13:32 ` R Sricharan
2012-11-14 16:44 ` Lokesh Vutla
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox