[U-Boot] [PATCH 3/5] Add fuse API and commands

[Stefano Babic <sbabic@denx.de>]

On 03/12/2012 12:25, Beno?t Th?baudeau wrote:
> Hi Stefano,
> 
> On Monday, December 3, 2012 10:03:22 AM, Stefano Babic wrote:
>> I am thinking about if we need some kind of protection to avoid to
>> destroy very easy the SOC. Running a fuse command can be much more
>> dangerous as scrubbing NAND or erasing flash.
>>
>> What about to add at least a "-y" option when we write the fuses, in
>> the
>> same way we have for the "nand scrub command" ? This does not forbid
>> to
>> use the command in scripts, but it can maybe avoid to destroy the SOC
>> when the command is wrong tipped on the console.
>>
>> What do you think ?
> 
> That makes sense. There could be the same kind of warning confirmation
> defaulting to no that would repeat which fuse is about to be programmed.
> 
> As to the value passed for fuse row programming or overriding, do you think that
> it's fine to force it to be hex, or that choice should be given with '0x'? I
> don't really like implicit base selection, but it's clear in the help message,
> and it is handy for writing MAC addresses without repeating the '0x' for each
> byte.

U-boot uses as default hex as base for numbers, not decimals, and if you
use hex as default you are consistent with the rest of code.

Best regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================