[U-Boot] [PATCH resend] usbh/ehci: Increase timeout for enumeration

[Igor Grinberg <grinberg@compulab.co.il>]

On 12/06/12 08:30, Vipin Kumar wrote:
> Few pen drives take longer than usual for enumeration. The u-boot unlike linux
> does not depend on interrupts and works in polling and timeout mode.
> 
> This patch increases this timeout to increase the set of usb sticks that can be
> enumerated by u-boot
> 
> Signed-off-by: Vipin Kumar <vipin.kumar@st.com>
> ---
>  common/usb_hub.c | 27 ++++++++++++++++++++++-----
>  1 file changed, 22 insertions(+), 5 deletions(-)
> 
> diff --git a/common/usb_hub.c b/common/usb_hub.c
> index e4a1201..24de9b7 100644
> --- a/common/usb_hub.c
> +++ b/common/usb_hub.c
> @@ -393,17 +393,34 @@ static int usb_hub_configure(struct usb_device *dev)
>  		"" : "no ");
>  	usb_hub_power_on(hub);
>  
> +	mdelay(1500);

a 1.5 seconds? This looks like a huge overkill...
Even for broken usb sticks...

> +
>  	for (i = 0; i < dev->maxchild; i++) {
>  		ALLOC_CACHE_ALIGN_BUFFER(struct usb_port_status, portsts, 1);
>  		unsigned short portstatus, portchange;
> +		int ret;
> +		ulong start = get_timer(0);
> +
> +		do {
> +			ret = usb_get_port_status(dev, i + 1, portsts);
> +			if (ret < 0) {
> +				USB_HUB_PRINTF("get_port_status failed\n");
> +				break;
> +			}
> +
> +			portstatus = le16_to_cpu(portsts->wPortStatus);
> +			portchange = le16_to_cpu(portsts->wPortChange);
> +
> +			if ((portchange & USB_PORT_STAT_C_CONNECTION) &&
> +				(portstatus & USB_PORT_STAT_CONNECTION))
> +				break;
>  
> -		if (usb_get_port_status(dev, i + 1, portsts) < 0) {
> -			USB_HUB_PRINTF("get_port_status failed\n");
> +			mdelay(100);
> +		} while (get_timer(start) < CONFIG_SYS_HZ * 10);
> +
> +		if (ret < 0)
>  			continue;
> -		}
>  
> -		portstatus = le16_to_cpu(portsts->wPortStatus);
> -		portchange = le16_to_cpu(portsts->wPortChange);
>  		USB_HUB_PRINTF("Port %d Status %X Change %X\n",
>  				i + 1, portstatus, portchange);
>  

-- 
Regards,
Igor.