From mboxrd@z Thu Jan 1 00:00:00 1970 From: Heiko Schocher Date: Thu, 17 Jan 2013 09:44:48 +0100 Subject: [U-Boot] Divide uboot into two parts In-Reply-To: <1358406350523-144917.post@n7.nabble.com> References: <1358406350523-144917.post@n7.nabble.com> Message-ID: <50F7BA00.6040200@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hello terryhuang, On 17.01.2013 08:05, terryhuang wrote: > Are there any ways to divide uboot into two parts, and burn into SPI NOR > Flash at different address? Why did you need this? > Limitation: first part of uboot will less than 128KB. This sounds like you could use the SPL framework. But you did not provide us some information about your hw, so it is hard to say, if the current spl code is supported ... look into the doc/README.SPL document in the u-boot source for more information about it. bye, Heiko -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany