[U-Boot] [PATCH 1/5] omap3: add useful dss defines

[Jeroen Hofstee <jeroen@myspectrum.nl>]

Hello Nikita,

+#define GFXFORMAT_ARGB32        0xC
>>> +#define GFXFORMAT_RGBA32        0xD
>>> +#define GFXFORMAT_RGBx32        0xE
>>> +
>>> +/* GFX burst size */
>>> +#define GFXBURSTSIZE4    0
>>> +#define GFXBURSTSIZE8    1
>>> +#define GFXBURSTSIZE16    2
>>> +
>>>   /* Panel Configuration */
>>>   struct panel_config {
>>>       u32 timing_h;
>> most defines in omap dss use the location in the silicon itself.
>> For consistency you might want to shift these values to the
>> appropriate place. (or just use 32 mode so you can drop most
>> if not all of them)
>>
>
> These aren't offsets against a base address. These are input values
> for the various sections of the dss registers. For example
> the /* GFX burst size */ defines are values for
> DISPC_GFX_ATTRIBUTES[7:6].
>

What I mean is that the defines currently in dss.h already shift the
values to the location where the hardware expects them, e.g..

/* Configure VENC DSS Params */
#define VENC_CLK_ENABLE                (1 << 3)
#define DAC_DEMEN                (1 << 4)
#define DAC_POWERDN                (1 << 5)
#define VENC_OUT_SEL                (1 << 6)

The defines you add are not shifted however, so after this patch half
of the defines need shifting, the other half does not. Thats confusing,
so macro's like

#define GFXBURSTSIZE8    (1 << 6)

is a better option in my opinion.

Regards,
Jeroen