[U-Boot] [PATCH v2] mx6qsabreauto: enable USB host interface

[U-Boot] [PATCH v2] mx6qsabreauto: enable USB host interface

[Dirk Behme]

From: Knut Wohlrab <knut.wohlrab@de.bosch.com>

The USB host interface is routed to plug USB1/J30 on the mother board.

Signed-off-by: Knut Wohlrab <knut.wohlrab@de.bosch.com>
---
Changes in v2:
- Don't add an empty board_ehci_hcd_init() to mx6qsabreauto.c. It's
  not needed because board_ehci_hcd_init() is declared as weak.

 include/configs/mx6qsabreauto.h |   11 +++++++++++
 1 files changed, 11 insertions(+), 0 deletions(-)

diff --git a/include/configs/mx6qsabreauto.h b/include/configs/mx6qsabreauto.h
index f4a082a..f2ff3e1 100644
--- a/include/configs/mx6qsabreauto.h
+++ b/include/configs/mx6qsabreauto.h
@@ -19,6 +19,17 @@
 #define CONFIG_MMCROOT			"/dev/mmcblk0p2"
 #define PHYS_SDRAM_SIZE		(2u * 1024 * 1024 * 1024)
 
+/* USB Configs */
+#define CONFIG_CMD_USB
+#define CONFIG_USB_EHCI
+#define CONFIG_USB_EHCI_MX6
+#define CONFIG_USB_STORAGE
+#define CONFIG_USB_HOST_ETHER
+#define CONFIG_USB_ETHER_ASIX
+#define CONFIG_MXC_USB_PORT	1
+#define CONFIG_MXC_USB_PORTSC	(PORT_PTS_UTMI | PORT_PTS_PTW)
+#define CONFIG_MXC_USB_FLAGS	0
+
 #include "mx6qsabre_common.h"
 
 #define CONFIG_SYS_FSL_USDHC_NUM	2
-- 
1.7.0.4

[U-Boot] [PATCH v2] mx6qsabreauto: enable USB host interface

[Stefano Babic]

On 22/01/2013 10:11, Dirk Behme wrote:
> From: Knut Wohlrab <knut.wohlrab@de.bosch.com>
> 
> The USB host interface is routed to plug USB1/J30 on the mother board.
> 
> Signed-off-by: Knut Wohlrab <knut.wohlrab@de.bosch.com>
> ---


Applied to u-boot-imx, thanks.

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================